Shenzhen Polaris Security Technology Co., Ltd.
Add to Cart
| Receiving frequency band | 2.4G/5.8G |
| Effective detection range | 500m-15km (varies by drone and environment) |
| Data refresh rate | ≥60 times/minute (close-range, Air3 test) |
| Positioning accuracy | ≤10m |
| Power supply | 5-36V |
| Antenna connector type | SMA female x 2 (internal board uses 2 x IPEX 1st generation female connector) |
| Communication interfaces | 1) Ethernet port: 1 2) UART serial communication interface: 2 channels, 3.3V-TTL, baud rate 115200 3) GPIO port: 8 |
| Operating power consumption | Analyzer module ≤5W; LNA ≤4W |
| Operating environment | -40°C to +65°C |
| Dimensions | Analyzer module: 100mm × 68mm × 14mm LNA: 84.5mm × 34mm × 19mm |
| Interface | Pin Number | Function Description | Remarks |
|---|---|---|---|
| 2.4GHz Antenna Port (SMA) | / | Connect a 2.4GHz antenna | In strong interference environments, additional bandpass filters are required |
| 5.8GHz Antenna Port (SMA) | / | Connect a 5.8GHz antenna | In strong interference environments, additional bandpass filters are required |
| 24/58 RF Output Port (SMA) | / | Output combined amplified 2.4GHz and 5.8GHz signal | Used to connect to the message analysis module RX1 |
| RET | / | Programming button | This button needs to be pressed when updating the firmware |
| Power supply and 3.3v TTL data interface (mx1.25) | 1 | ACC | 5-36V |
| 2 | GND | ||
| 3 | GND | ||
| 4 | TXD | ||
| 5 | RXD |